Gear & Centrifugal Pumps in Venâncio Aires

Yes. In addition to the standard portfolio, FB Bombas develops custom solutions for special applications, including modifications in construction materials, sealing arrangements, integrated heating systems, skids, mobile assemblies and retrofit of existing installations. Special projects go through engineering before manufacturing.

FB Bombas' trajectory as an industrial pump manufacturer began in 1944 and adds up to over 82 years of continuous experience. Engineering, manufacturing and testing operate under one roof at the Cabreúva/SP factory — a guarantee of total quality control on every unit that reaches Venâncio Aires and the rest of Brazil.

FB Bombas' rotating set balancing follows ISO 21940 G2.5 — a grade equivalent to the API 610 requirement for heavy-duty service. It is the level demanded in critical Venâncio Aires projects: continuous regime, plants with online vibration monitoring or operations where unplanned downtime is expensive. Above 3,600 RPM or with rotating mass beyond 50 kg, balancing is done on two planes, with a piezoelectric sensor.

FB Bombas manufactures four major lines: FBE (external gear) for viscous fluids, FBEI (internal gear) for lubricating fluids, FBCN (normalized centrifugal) for water and low-viscosity fluids, and FBOT (specific centrifugal) for thermal oil circuits. We also serve fire protection systems in compliance with NFPA and NBR 16704.

It depends on the configuration: standard-arrangement pumps have shorter lead times, while special constructions follow the schedule stated in the technical proposal. The deciding factor is the combination of series, materials and stock availability — and transport to Venâncio Aires goes through our regular road operator.

It directly affects viscous fluids: viscosity at winter cold start can be several times higher than at operation, raising the torque demanded from the motor. For oils, asphalt and resins, engineering evaluates a heating jacket and sizes the drive for the most severe condition — not the average.

Maximum temperature depends on the series: FBE and FBEI operate up to 350°C with heating jacket and special sealing; FBOT operates up to 350°C in thermal oil circuits; FBCN operates up to 260°C with proper materials and sealing. Correct sizing of sealing and materials is essential for safe operation.

Yes. FB Bombas offers technical training for operations and maintenance teams in Venâncio Aires, with modules on: sizing and reading the characteristic curve, identifying cavitation through NPSH, mechanical-seal troubleshooting, laser alignment, ISO 10816 vibration analysis and PM (preventive maintenance) practice with bearing and wear-ring replacement. Training can be delivered at the customer plant or at the Cabreúva/SP factory, in person or hybrid.

Yes. Every FB Bombas pump delivered to Venâncio Aires comes with a complete technical Data Book: hydraulic test certificate, material certificates (stainless, duplex, ductile cast iron per spec), ISO 21940 G2.5 balancing report, characteristic curve measured on the bench, API 682 mechanical-seal data sheets, operation and maintenance manual, and as-built drawings. All documentation is traceable by the unit serial number.

Yes. On the factory bench in Cabreúva/SP the FAT (Factory Acceptance Test) is carried out: hydraulic test with characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. The SAT (Site Acceptance Test) on Venâncio Aires projects counts on application engineering during commissioning, including startup checklist, laser alignment and recording of the baseline vibration signature.