Gear & Centrifugal Pumps in Vacaria

Shorter delivery times (no import dependency), direct technical support from FB engineering, replacement parts with in-house manufacturing, prices in local currency (no exchange rate exposure) and on-site service for projects in Vacaria and surrounding areas. FB Bombas has been manufacturing in Brazil since 1944.

Yes — Vacaria is part of FB Bombas’ direct service area. Supply, engineering support and spare parts ship from the factory in Cabreúva/SP; sizing is done at no cost and, when the project is critical, the team evaluates an on-site technical visit.

Yes. FB Bombas’ application engineering analyzes the installed pump specifications (flow, pressure, viscosity, temperature) and proposes dimensional or functional technical equivalence with one of our series. Many clients in Vacaria have already made this replacement with gains in lead time, cost and local support.

There is no single configuration — engineering selects the mechanical seal based on the fluid, temperature and operating pressure. The range includes single seals, double seals in tandem or back-to-back arrangement, cartridge seals and packing glands in specific applications. When the fluid is hazardous, the recommendation is a double seal with barrier.

The FB line covers a wide range: mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins, viscous chemical and hydraulic products (FBE series); raw and treated water, process fluids, industrial effluents (FBCN series); thermal oil at elevated temperatures (FBOT series). Each application is sized according to fluid viscosity, temperature and chemical compatibility.

Just use one of the channels: WhatsApp +55 11 97287-4837, email comercial@fbbombas.com.br or the website form. Describe the application — fluid, flow, pressure, temperature — and the technical team replies with a proposal sized for your conditions in Vacaria.

Yes. FB Bombas application engineering supports ISO 10816 vibration analysis (velocity RMS in mm/s) for diagnosing misalignment, imbalance, bearing defects and cavitation on pumps installed in Vacaria. The service includes baseline capture at startup, spectral comparison during PM campaigns, and intervention recommendations (re-balancing, bearing replacement, laser alignment) before vibration exceeds the standard’s zone D.

Maximum temperature depends on the series: FBE and FBEI operate up to 350°C with heating jacket and special sealing; FBOT operates up to 350°C in thermal oil circuits; FBCN operates up to 260°C with proper materials and sealing. Correct sizing of sealing and materials is essential for safe operation.

Yes, when the dimension designation matches. The FBCN series follows ASME B73.1 (North American dimensional standard for end-suction process pumps), which requires pumps of the same designation, from any source of supply, to be interchangeable as to mounting dimensions, suction and discharge nozzles, input shaft, baseplate and foundation bolt holes — in Vacaria plants this applies to the installed normalized fleet. FB Bombas supplies the complete pump, not loose parts: baseplate, piping and foundation stay, and a new FBCN goes in. Before supply, application engineering checks the duty point (Q×H), available NPSH and flange class — a matching designation alone does not guarantee hydraulic equivalence.

It directly affects viscous fluids: viscosity at winter cold start can be several times higher than at operation, raising the torque demanded from the motor. For oils, asphalt and resins, engineering evaluates a heating jacket and sizes the drive for the most severe condition — not the average.