FBCN Centrifugal Pumps in Santo Antônio

They do. The FBCN series dimensionally meets ASME B73.1, the North American standard for horizontal end-suction process centrifugal pumps. In practice, a Santo Antônio plant running a normalized pump of the same designation achieves retrofit on the already-installed baseplate: since shaft dimensions, suction/discharge flanges, casing feet and impeller centerline follow the same standard, the FBCN pump takes the place of the previous one — piping and baseplate stay intact. Hydraulic equivalence (Q×H and NPSH) is checked separately, on the data sheet.

There is no single configuration — engineering selects the mechanical seal based on the fluid, temperature and operating pressure. The range includes single seals, double seals in tandem or back-to-back arrangement, cartridge seals and packing glands in specific applications. When the fluid is hazardous, the recommendation is a double seal with barrier.

Yes. As a Brazilian manufacturer accredited in FINAME — the BNDES Special Industrial Financing Agency —, FB Bombas qualifies equipment supplied to Santo Antônio for BNDES Finame financing lines (Industrial Working Capital, Modernization, Capital Goods), with preferential conditions for national industry. On the technical proposal, the commercial team includes the product's FINAME code to enter the customer's financial plan.

The FB line covers a wide range: mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins, viscous chemical and hydraulic products (FBE series); raw and treated water, process fluids, industrial effluents (FBCN series); thermal oil at elevated temperatures (FBOT series). Each application is sized according to fluid viscosity, temperature and chemical compatibility.

Shipment is by road via BR-101 (via PB), with industrial packaging suited to the journey and tracking until delivery. Sizing, proposal and technical support run in parallel through remote channels — distance does not change the engineering scope, only the logistics planning, reflected in the proposal schedule.

Yes. On pumps installed in Santo Antônio, FB Bombas application engineering applies ISO 10816 (velocity RMS in mm/s) to diagnose misalignment, imbalance, bearing defects and cavitation. The scope covers baseline captured at startup, spectral comparison throughout PM campaigns and recommendation of interventions — re-balancing, bearing replacement, laser alignment — before the machine reaches the standard's zone D.

Yes. For stationary fire protection systems, FB Bombas produces pumps compliant with NFPA (National Fire Protection Association) and with ABNT's NBR 16704 — covering building and industrial projects that demand these certifications.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Santo Antônio, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

FB Bombas' trajectory as an industrial pump manufacturer began in 1944 and adds up to over 82 years of continuous experience. Engineering, manufacturing and testing operate under one roof at the Cabreúva/SP factory — a guarantee of total quality control on every unit that reaches Santo Antônio and the rest of Brazil.

Yes. FB Bombas serves the entire metropolitan region and microregions neighboring Santo Antônio with the same technical support and logistics structure. This regional reach allows serving industrial plants distributed across multiple cities in a coordinated way.