FBCN Centrifugal Pumps in Itatiaia

There is no single configuration — engineering selects the mechanical seal based on the fluid, temperature and operating pressure. The range includes single seals, double seals in tandem or back-to-back arrangement, cartridge seals and packing glands in specific applications. When the fluid is hazardous, the recommendation is a double seal with barrier.

Yes. FB Bombas application engineering supports ISO 10816 vibration analysis (velocity RMS in mm/s) for diagnosing misalignment, imbalance, bearing defects and cavitation on pumps installed in Itatiaia. The service includes baseline capture at startup, spectral comparison during PM campaigns, and intervention recommendations (re-balancing, bearing replacement, laser alignment) before vibration exceeds the standard’s zone D.

Yes — and the secret lies in correct sizing, the main lever for energy efficiency. Both an oversized and an undersized pump waste energy. That is why FB Bombas engineering determines the optimal operating point from the actual process conditions in Itatiaia, balancing the flow/pressure/power ratio.

Every FB pump leaves the factory with a warranty against manufacturing defects, under the terms detailed in the commercial proposal. The condition is that installation, operation and maintenance respect the manual's parameters and the sizing defined by engineering. For details on your project in Itatiaia, talk to our technical team.

Limits vary by series. FBE and FBEI: up to 350°C, provided a heating jacket and special sealing are used. FBOT: up to 350°C in thermal oil circuits. FBCN: up to 260°C, with materials and sealing suited to the service. Well-sized sealing and materials are a condition for safe operation in these ranges.

FB Bombas holds: active CRCC at Petrobras (supplier registry for Oil & Gas); compliance with API 676 (international standard for positive displacement pumps — FBE series); compliance with ASME B73.1 (standard for process centrifugal pumps — FBCN series); compliance with NFPA (National Fire Protection Association) standards and ABNT NBR 16704 for stationary fire protection pump systems.

Yes. Since FB Bombas manufactures entirely in Cabreúva/SP, replacement parts for the FBE, FBEI, FBCN and FBOT series are available directly from the factory, with short lead times for scheduled stops and priority service for emergencies. This significantly reduces total cost of ownership.

Yes. For projects in Itatiaia, on-site technical visits by application engineers can be scheduled for process data collection, diagnosis of existing installations and commissioning support. Geographic proximity makes this operation agile and recurring.

Yes. A complete technical Data Book accompanies each FB Bombas pump that reaches Itatiaia: hydraulic test certificate, material certificates (stainless steel, duplex and ductile cast iron per spec), ISO 21940 G2.5 balancing report, characteristic curve measured on the test bench, API 682 mechanical-seal data sheets, operation and maintenance manual and as-built drawings. The unit serial number traces all this documentation.

They do. The FBCN series dimensionally meets ASME B73.1, the North American standard for horizontal end-suction process centrifugal pumps. In practice, a Itatiaia plant running a normalized pump of the same designation achieves retrofit on the already-installed baseplate: since shaft dimensions, suction/discharge flanges, casing feet and impeller centerline follow the same standard, the FBCN pump takes the place of the previous one — piping and baseplate stay intact. Hydraulic equivalence (Q×H and NPSH) is checked separately, on the data sheet.