Gear & Centrifugal Pumps in Aroeiras

Yes — Aroeiras is part of FB Bombas’ direct service area. Supply, engineering support and spare parts ship from the factory in Cabreúva/SP; sizing is done at no cost and, when the project is critical, the team evaluates an on-site technical visit.

Lead time depends on the chosen series, construction materials and stock availability. For standard configuration pumps, lead times are shorter; for special or custom constructions, the schedule is informed in the technical proposal. Logistics for Aroeiras is handled by our regular road operator.

Yes — and the secret lies in correct sizing, the main lever for energy efficiency. Both an oversized and an undersized pump waste energy. That is why FB Bombas engineering determines the optimal operating point from the actual process conditions in Aroeiras, balancing the flow/pressure/power ratio.

They can. FB Bombas' accreditation in FINAME (the BNDES Special Industrial Financing Agency), as a Brazilian manufacturer, makes equipment destined for Aroeiras eligible for the BNDES Finame lines — Industrial Working Capital, Modernization and Capital Goods —, which offer preferential conditions for national industry. The product's FINAME code is provided by the commercial team on the technical proposal, ready to compose the customer's financial plan.

Yes — with a structural advantage: since the FBE, FBEI, FBCN and FBOT series are manufactured entirely in Brazil, parts ship from the factory itself in Cabreúva/SP, with short lead times for planned shutdowns and priority handling for emergencies. The direct effect is a lower total cost of ownership.

It is compatible when the dimension designation is the same. ASME B73.1 (North American dimensional standard for end-suction process pumps), adopted in the FBCN series, defines an envelope common to the whole normalized fleet operating in Aroeiras plants, whoever manufactured the installed unit. In a typical retrofit, baseplate, suction/discharge piping and foundations are preserved, and FB Bombas supplies the complete new pump — not loose parts for third-party equipment. The dimensional and hydraulic gap analysis is executed by application engineering before supplying.

It does. The standard used is ISO 10816, with velocity RMS in mm/s, and the diagnosis — conducted by FB Bombas application engineering — identifies misalignment, imbalance, bearing defects and cavitation on pumps operating in Aroeiras. At startup the baseline is captured; in PM campaigns, spectral comparison is performed; and interventions (re-balancing, bearing replacement, laser alignment) are recommended before vibration enters zone D.

It does. FB Bombas' retrofit service for existing installations encompasses updated seals, replaced worn components, adjustment to new fluids and improved hydraulic performance. To evaluate each case, the reference is the technical report on the current installation.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Aroeiras, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

They are. For each delivery to Aroeiras, FB Bombas assembles the unit's complete technical Data Book, containing: hydraulic test certificate, material certificates — stainless steel, duplex or ductile cast iron, per spec —, ISO 21940 G2.5 balancing report, characteristic curve obtained on the bench, API 682 mechanical-seal data sheets, operation and maintenance manual and as-built drawings. Full traceability happens through the serial number.