Gear & Centrifugal Pumps in São Domingos do Capim

Shipment is by road via BR-010 / BR-153 Rodovia Belém-Brasília, with industrial packaging suited to the journey and tracking until delivery. Sizing, proposal and technical support run in parallel through remote channels — distance does not change the engineering scope, only the logistics planning, reflected in the proposal schedule.

Yes. On pumps installed in São Domingos do Capim, FB Bombas application engineering applies ISO 10816 (velocity RMS in mm/s) to diagnose misalignment, imbalance, bearing defects and cavitation. The scope covers baseline captured at startup, spectral comparison throughout PM campaigns and recommendation of interventions — re-balancing, bearing replacement, laser alignment — before the machine reaches the standard's zone D.

The portfolio covers four in-house series: FBE (external gear) for viscous fluids, FBEI (internal gear) for low-pulsation services, FBCN (standardized centrifugal) for water and light fluids and FBOT (dedicated centrifugal) for thermal oil — plus complete fire-fighting systems per NFPA 20 and NBR 16704.

Each series has its thermal limit: with heating jacket and special sealing, FBE and FBEI reach 350°C; FBOT hits the same 350°C in thermal oil circuits; FBCN goes up to 260°C when fitted with proper materials and sealing. Safe operation requires correctly sized sealing and materials.

It is compatible when the dimension designation is the same. ASME B73.1 (North American dimensional standard for end-suction process pumps), adopted in the FBCN series, defines an envelope common to the whole normalized fleet operating in São Domingos do Capim plants, whoever manufactured the installed unit. In a typical retrofit, baseplate, suction/discharge piping and foundations are preserved, and FB Bombas supplies the complete new pump — not loose parts for third-party equipment. The dimensional and hydraulic gap analysis is executed by application engineering before supplying.

FB Bombas' rotating set balancing follows ISO 21940 G2.5 — a grade equivalent to the API 610 requirement for heavy-duty service. It is the level demanded in critical São Domingos do Capim projects: continuous regime, plants with online vibration monitoring or operations where unplanned downtime is expensive. Above 3,600 RPM or with rotating mass beyond 50 kg, balancing is done on two planes, with a piezoelectric sensor.

It does. The technical support and logistics covering São Domingos do Capim are the same applied to the metropolitan region and nearby microregions. That operating radius enables coordinated service to industrial plants distributed across several cities.

Yes. FB Bombas serves São Domingos do Capim and the entire surrounding region with supply, technical support and replacement parts directly from the factory in Cabreúva/SP. Support includes sizing at no cost and, for critical projects, on-site technical visits.

Yes. Since FB Bombas manufactures entirely in Cabreúva/SP, replacement parts for the FBE, FBEI, FBCN and FBOT series are available directly from the factory, with short lead times for scheduled stops and priority service for emergencies. This significantly reduces total cost of ownership.

The FB line covers a wide range: mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins, viscous chemical and hydraulic products (FBE series); raw and treated water, process fluids, industrial effluents (FBCN series); thermal oil at elevated temperatures (FBOT series). Each application is sized according to fluid viscosity, temperature and chemical compatibility.