Gear & Centrifugal Pumps in Capinópolis

FB Bombas' rotating set balancing follows ISO 21940 G2.5 — a grade equivalent to the API 610 requirement for heavy-duty service. It is the level demanded in critical Capinópolis projects: continuous regime, plants with online vibration monitoring or operations where unplanned downtime is expensive. Above 3,600 RPM or with rotating mass beyond 50 kg, balancing is done on two planes, with a piezoelectric sensor.

Yes. Correct sizing is the main lever for energy efficiency — an oversized or undersized pump wastes energy. FB Bombas engineering calculates the optimal operating point considering the actual process conditions in Capinópolis, optimizing the flow/pressure/power ratio.

Coverage against manufacturing defects accompanies the supply of FB pumps — the full terms appear in the commercial proposal. It holds as long as installation, operation and maintenance follow what the manual specifies and the sizing performed by engineering. Our technical team clarifies the specific conditions of your project in Capinópolis.

Yes. The entire metropolitan region and the microregions around Capinópolis receive from FB Bombas the same technical support and logistics structure. With this regional reach, industrial plants spread across several cities are served in a coordinated manner.

Send flow, differential pressure, working temperature and fluid viscosity: with these four data points FB engineering calculates the right model, also validating available NPSH, operating regime and material compatibility. The service is free of charge for customers in Capinópolis.

Since 1944 — over 82 years of continuous experience manufacturing industrial pumps. In Cabreúva/SP, the factory brings engineering, manufacturing and testing together under one roof, which assures total quality control on each unit shipped to Capinópolis and all across Brazil.

It offers both. The FAT (Factory Acceptance Test) takes place on the Cabreúva/SP bench and covers hydraulic testing, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration; when the customer specifies, inspection witnesses the tests. In the SAT (Site Acceptance Test) of Capinópolis projects, application engineering supports commissioning with startup checklist, laser alignment and capture of the baseline vibration signature.

Each series has its thermal limit: with heating jacket and special sealing, FBE and FBEI reach 350°C; FBOT hits the same 350°C in thermal oil circuits; FBCN goes up to 260°C when fitted with proper materials and sealing. Safe operation requires correctly sized sealing and materials.

Yes, when the dimension designation matches. The FBCN series follows ASME B73.1 (North American dimensional standard for end-suction process pumps), which requires pumps of the same designation, from any source of supply, to be interchangeable as to mounting dimensions, suction and discharge nozzles, input shaft, baseplate and foundation bolt holes — in Capinópolis plants this applies to the installed normalized fleet. FB Bombas supplies the complete pump, not loose parts: baseplate, piping and foundation stay, and a new FBCN goes in. Before supply, application engineering checks the duty point (Q×H), available NPSH and flange class — a matching designation alone does not guarantee hydraulic equivalence.

Yes. On pumps installed in Capinópolis, FB Bombas application engineering applies ISO 10816 (velocity RMS in mm/s) to diagnose misalignment, imbalance, bearing defects and cavitation. The scope covers baseline captured at startup, spectral comparison throughout PM campaigns and recommendation of interventions — re-balancing, bearing replacement, laser alignment — before the machine reaches the standard's zone D.