Gear & Centrifugal Pumps in Amambai

Yes. The process starts with FB Bombas' application engineering, which studies the installed pump's specifications — flow, pressure, viscosity, temperature — and indicates the dimensional or functional technical equivalence within our series. In Amambai, many clients have already completed this swap and gained in lead time, cost and local support.

They are. The ASME B73.1 normalization (North American dimensional standard for end-suction process pumps) adopted in the FBCN series makes the pump-and-motor set swappable with KSB, Sulzer, Goulds and Flowserve units already operating in Amambai plants. In a typical retrofit, baseplate, suction/discharge piping and foundations are preserved — only the rotating set is replaced. The dimensional gap analysis is executed by FB application engineering before supplying.

Yes. Operations and maintenance teams in Amambai count on FB Bombas technical training, structured in modules: sizing and characteristic-curve reading, identifying cavitation through NPSH, mechanical-seal troubleshooting, laser alignment, ISO 10816 vibration analysis and PM (preventive maintenance) practice with bearing and wear-ring replacement. Classes can happen at the customer plant or at the factory in Cabreúva/SP, in-person or hybrid format.

For water, condensate and low-viscosity fluids, the recommendation is the FBCN standardized centrifugal — 53 models with bench-tested curves and back-pull-out maintenance, which frees the rotating assembly without dismantling the piping. The exact model comes from the circuit’s flow × head pair.

Yes. FB Bombas offers retrofit of existing installations, including seal upgrades, replacement of worn components, adaptation for new fluids and hydraulic performance improvement. The assessment is based on a technical report of the current installation.

It is. A Brazilian manufacturer since 1944, FB Bombas runs its factory in Cabreúva/SP and keeps a technical team focused on projects in Amambai. Where global manufacturers operate — KSB, Sulzer, Imbil, Grundfos —, the FBCN (centrifugal), FBE/FBEI (gear) and FBOT (thermal oil) series offer equivalent coverage, with better lead times by dispensing with imports, factory-direct technical support, agile parts replacement and Portuguese-speaking application engineering. For retrofits, existing baseplates keep dimensional interchangeability thanks to ASME B73.1 normalization.

Each series has its thermal limit: with heating jacket and special sealing, FBE and FBEI reach 350°C; FBOT hits the same 350°C in thermal oil circuits; FBCN goes up to 260°C when fitted with proper materials and sealing. Safe operation requires correctly sized sealing and materials.

Yes. FBOT is FB Bombas’ specific centrifugal pump for thermal oil circuits, operating at elevated temperatures with fluids like Therminol, Dowtherm and similar. Material and sealing selection is done according to the maximum operating temperature and type of thermal oil.

FBE external gear pumps can operate with fluids up to 100,000 SSU (approximately 22,000 cSt). For very high viscosities, rotation is reduced to maintain volumetric efficiency and component life. Engineering sizes each application in Amambai according to the actual viscosity profile.

It does. The technical support and logistics covering Amambai are the same applied to the metropolitan region and nearby microregions. That operating radius enables coordinated service to industrial plants distributed across several cities.