FBCN Centrifugal Pumps in Araguaína

Yes. Correct sizing is the main lever for energy efficiency — an oversized or undersized pump wastes energy. FB Bombas engineering calculates the optimal operating point considering the actual process conditions in Araguaína, optimizing the flow/pressure/power ratio.

Since 1944 — over 82 years of continuous experience manufacturing industrial pumps. In Cabreúva/SP, the factory brings engineering, manufacturing and testing together under one roof, which assures total quality control on each unit shipped to Araguaína and all across Brazil.

Yes. Every FB Bombas pump delivered to Araguaína comes with a complete technical Data Book: hydraulic test certificate, material certificates (stainless, duplex, ductile cast iron per spec), ISO 21940 G2.5 balancing report, characteristic curve measured on the bench, API 682 mechanical-seal data sheets, operation and maintenance manual, and as-built drawings. All documentation is traceable by the unit serial number.

Yes. On pumps installed in Araguaína, FB Bombas application engineering applies ISO 10816 (velocity RMS in mm/s) to diagnose misalignment, imbalance, bearing defects and cavitation. The scope covers baseline captured at startup, spectral comparison throughout PM campaigns and recommendation of interventions — re-balancing, bearing replacement, laser alignment — before the machine reaches the standard's zone D.

Yes. The entire metropolitan region and the microregions around Araguaína receive from FB Bombas the same technical support and logistics structure. With this regional reach, industrial plants spread across several cities are served in a coordinated manner.

Yes. FB Bombas is a Brazilian manufacturer accredited in FINAME (BNDES Special Industrial Financing Agency), which qualifies equipment supplied to Araguaína for BNDES Finame financing lines (Industrial Working Capital, Modernization, Capital Goods) with preferential conditions for national industry. The commercial team provides the product FINAME code on the technical proposal for inclusion in the customer financial plan.

Maximum temperature depends on the series: FBE and FBEI operate up to 350°C with heating jacket and special sealing; FBOT operates up to 350°C in thermal oil circuits; FBCN operates up to 260°C with proper materials and sealing. Correct sizing of sealing and materials is essential for safe operation.

The portfolio covers four in-house series: FBE (external gear) for viscous fluids, FBEI (internal gear) for low-pulsation services, FBCN (standardized centrifugal) for water and light fluids and FBOT (dedicated centrifugal) for thermal oil — plus complete fire-fighting systems per NFPA 20 and NBR 16704.

Yes, provided the dimension designation coincides. By following ASME B73.1 — the North American dimensional standard for end-suction process pumps — the FBCN occupies the standardised installation envelope defined by the norm, which does not depend on who built the pump running in Araguaína plants. What is supplied is the complete pump: baseplate, suction/discharge piping and foundations usually remain. FB application engineering runs the dimensional gap analysis before supply, covering flow, head and required NPSH as well.

Yes. On the factory bench in Cabreúva/SP the FAT (Factory Acceptance Test) is carried out: hydraulic test with characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. The SAT (Site Acceptance Test) on Araguaína projects counts on application engineering during commissioning, including startup checklist, laser alignment and recording of the baseline vibration signature.