FBCN Centrifugal Pumps in Nilópolis

The FB portfolio handles an extensive spectrum of fluids. The FBE series takes mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins plus viscous chemical and hydraulic products; the FBCN series works with raw and treated water, process fluids and industrial effluents; the FBOT series is dedicated to thermal oil at elevated temperatures. Each case is sized considering viscosity, temperature and chemical compatibility.

Yes. The process starts with FB Bombas' application engineering, which studies the installed pump's specifications — flow, pressure, viscosity, temperature — and indicates the dimensional or functional technical equivalence within our series. In Nilópolis, many clients have already completed this swap and gained in lead time, cost and local support.

Yes. On the factory bench in Cabreúva/SP the FAT (Factory Acceptance Test) is carried out: hydraulic test with characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. The SAT (Site Acceptance Test) on Nilópolis projects counts on application engineering during commissioning, including startup checklist, laser alignment and recording of the baseline vibration signature.

Yes. By following ASME B73.1 — the North American dimensional standard for end-suction process pumps —, the FBCN series delivers a pump-and-motor set interchangeable with equipment from global manufacturers (KSB, Sulzer, Goulds, Flowserve) present in Nilópolis plants. In a retrofit, the existing baseplate, suction/discharge piping and foundations usually remain; the swap focuses on the rotating set. Prior to supply, FB application engineering conducts the dimensional gap analysis.

To receive a technical quote for industrial pumps in Nilópolis, send via website form, WhatsApp +55 11 97287-4837 or email comercial@fbbombas.com.br the application data: fluid (name + viscosity at operating temperature), target flow (m³/h), discharge head (m), available NPSH, operating temperature and regime (continuous or intermittent). Application engineering responds with a preliminary technical proposal, characteristic curve, suggested materials and delivery lead time.

When there is a plant shutdown in Nilópolis, FB Bombas triggers an emergency flow dedicated to critical parts (mechanical seal, impeller, shaft, wear ring, bearings): the order gets pre-invoicing, dispatch is prioritized and the modal can change — express road or air, decided by distance and criticality. The region defines the typical lead time, with a window negotiable for each case. For those with an installed base and scheduled PM, there is the option of consigning part of the stock at the plant.

It does. FB pumps for stationary fire protection systems follow the NFPA standard (National Fire Protection Association) and ABNT's NBR 16704, requirements demanded in building and industrial projects that call for these certifications.

Limits vary by series. FBE and FBEI: up to 350°C, provided a heating jacket and special sealing are used. FBOT: up to 350°C in thermal oil circuits. FBCN: up to 260°C, with materials and sealing suited to the service. Well-sized sealing and materials are a condition for safe operation in these ranges.

Yes — with a structural advantage: since the FBE, FBEI, FBCN and FBOT series are manufactured entirely in Brazil, parts ship from the factory itself in Cabreúva/SP, with short lead times for planned shutdowns and priority handling for emergencies. The direct effect is a lower total cost of ownership.

It is. A Brazilian manufacturer since 1944, FB Bombas runs its factory in Cabreúva/SP and keeps a technical team focused on projects in Nilópolis. Where global manufacturers operate — KSB, Sulzer, Imbil, Grundfos —, the FBCN (centrifugal), FBE/FBEI (gear) and FBOT (thermal oil) series offer equivalent coverage, with better lead times by dispensing with imports, factory-direct technical support, agile parts replacement and Portuguese-speaking application engineering. For retrofits, existing baseplates keep dimensional interchangeability thanks to ASME B73.1 normalization.