FBCN Centrifugal Pumps in Cianorte

Yes. On pumps installed in Cianorte, FB Bombas application engineering applies ISO 10816 (velocity RMS in mm/s) to diagnose misalignment, imbalance, bearing defects and cavitation. The scope covers baseline captured at startup, spectral comparison throughout PM campaigns and recommendation of interventions — re-balancing, bearing replacement, laser alignment — before the machine reaches the standard's zone D.

Mechanical seal configuration is defined by engineering according to the fluid, temperature and operating pressure. Options include single seals, double seals (tandem or back-to-back), cartridge seals and packing glands for specific applications. For hazardous fluids, double seals with barrier are recommended.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Cianorte, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

During a plant shutdown in Cianorte, critical parts — mechanical seal, impeller, shaft, wear ring, bearings — enter FB Bombas' emergency flow: pre-invoicing, priority dispatch and choice of alternative modal (express road or air, depending on distance and criticality). Typical lead time depends on the region and the window is negotiated case by case. Customers with an installed base and scheduled PM can keep part of the stock on consignment at the plant.

Yes. FB Bombas serves the entire metropolitan region and microregions neighboring Cianorte with the same technical support and logistics structure. This regional reach allows serving industrial plants distributed across multiple cities in a coordinated way.

It directly affects viscous fluids: viscosity at winter cold start can be several times higher than at operation, raising the torque demanded from the motor. For oils, asphalt and resins, engineering evaluates a heating jacket and sizes the drive for the most severe condition — not the average.

There are three channels: WhatsApp +55 11 97287-4837, email comercial@fbbombas.com.br and the form on our website. Technical questions get priority response within the same business day — the reply comes directly from application engineering.

The FB Bombas rotating set is balanced per ISO 21940 G2.5 (a balancing grade equivalent to API 610 requirements for heavy-duty service) — required for critical projects in Cianorte with continuous regime, plants with online vibration monitoring or applications with high cost of unplanned downtime. For machines running above 3,600 RPM or with rotating mass over 50 kg, balancing is performed on two planes with a piezoelectric sensor.

Four pillars: a current Petrobras CRCC registration for Oil & Gas; API 676 (positive displacement) on the FBE series; ASME B73.1 (process centrifugals) on the FBCN series; and NFPA 20 / NBR 16704 compliance for stationary fire pumps.

It is compatible when the dimension designation is the same. ASME B73.1 (North American dimensional standard for end-suction process pumps), adopted in the FBCN series, defines an envelope common to the whole normalized fleet operating in Cianorte plants, whoever manufactured the installed unit. In a typical retrofit, baseplate, suction/discharge piping and foundations are preserved, and FB Bombas supplies the complete new pump — not loose parts for third-party equipment. The dimensional and hydraulic gap analysis is executed by application engineering before supplying.