FBCN Centrifugal Pumps in Peçanha

The FB portfolio handles an extensive spectrum of fluids. The FBE series takes mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins plus viscous chemical and hydraulic products; the FBCN series works with raw and treated water, process fluids and industrial effluents; the FBOT series is dedicated to thermal oil at elevated temperatures. Each case is sized considering viscosity, temperature and chemical compatibility.

It depends on the configuration: standard-arrangement pumps have shorter lead times, while special constructions follow the schedule stated in the technical proposal. The deciding factor is the combination of series, materials and stock availability — and transport to Peçanha goes through our regular road operator.

Yes — the standard catalog is only the starting point. For special applications, FB Bombas engineers custom solutions: changes in construction materials, sealing arrangements, integrated heating systems, skids, mobile assemblies and retrofit of existing installations. Before manufacturing, every special project is validated by engineering.

Yes. Existing installations can undergo retrofit with FB Bombas — the scope covers seal upgrades, swapping worn components, adaptation for new fluids and hydraulic performance gains. A technical report on the current installation serves as the basis for the assessment.

Yes. Operations and maintenance teams in Peçanha count on FB Bombas technical training, structured in modules: sizing and characteristic-curve reading, identifying cavitation through NPSH, mechanical-seal troubleshooting, laser alignment, ISO 10816 vibration analysis and PM (preventive maintenance) practice with bearing and wear-ring replacement. Classes can happen at the customer plant or at the factory in Cabreúva/SP, in-person or hybrid format.

Yes. A complete technical Data Book accompanies each FB Bombas pump that reaches Peçanha: hydraulic test certificate, material certificates (stainless steel, duplex and ductile cast iron per spec), ISO 21940 G2.5 balancing report, characteristic curve measured on the test bench, API 682 mechanical-seal data sheets, operation and maintenance manual and as-built drawings. The unit serial number traces all this documentation.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Peçanha, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

Yes. Correct sizing is the main lever for energy efficiency — an oversized or undersized pump wastes energy. FB Bombas engineering calculates the optimal operating point considering the actual process conditions in Peçanha, optimizing the flow/pressure/power ratio.

Yes — Peçanha is part of FB Bombas’ direct service area. Supply, engineering support and spare parts ship from the factory in Cabreúva/SP; sizing is done at no cost and, when the project is critical, the team evaluates an on-site technical visit.

Yes. On pumps installed in Peçanha, FB Bombas application engineering applies ISO 10816 (velocity RMS in mm/s) to diagnose misalignment, imbalance, bearing defects and cavitation. The scope covers baseline captured at startup, spectral comparison throughout PM campaigns and recommendation of interventions — re-balancing, bearing replacement, laser alignment — before the machine reaches the standard's zone D.