FBE Gear Pumps in Itaguaí

Yes — with a structural advantage: since the FBE, FBEI, FBCN and FBOT series are manufactured entirely in Brazil, parts ship from the factory itself in Cabreúva/SP, with short lead times for planned shutdowns and priority handling for emergencies. The direct effect is a lower total cost of ownership.

FB Bombas' trajectory as an industrial pump manufacturer began in 1944 and adds up to over 82 years of continuous experience. Engineering, manufacturing and testing operate under one roof at the Cabreúva/SP factory — a guarantee of total quality control on every unit that reaches Itaguaí and the rest of Brazil.

For water, condensate and low-viscosity fluids, the recommendation is the FBCN standardized centrifugal — 53 models with bench-tested curves and back-pull-out maintenance, which frees the rotating assembly without dismantling the piping. The exact model comes from the circuit’s flow × head pair.

Yes. In addition to the standard portfolio, FB Bombas develops custom solutions for special applications, including modifications in construction materials, sealing arrangements, integrated heating systems, skids, mobile assemblies and retrofit of existing installations. Special projects go through engineering before manufacturing.

There is no single configuration — engineering selects the mechanical seal based on the fluid, temperature and operating pressure. The range includes single seals, double seals in tandem or back-to-back arrangement, cartridge seals and packing glands in specific applications. When the fluid is hazardous, the recommendation is a double seal with barrier.

It is compatible when the dimension designation is the same. ASME B73.1 (North American dimensional standard for end-suction process pumps), adopted in the FBCN series, defines an envelope common to the whole normalized fleet operating in Itaguaí plants, whoever manufactured the installed unit. In a typical retrofit, baseplate, suction/discharge piping and foundations are preserved, and FB Bombas supplies the complete new pump — not loose parts for third-party equipment. The dimensional and hydraulic gap analysis is executed by application engineering before supplying.

Send flow, differential pressure, working temperature and fluid viscosity: with these four data points FB engineering calculates the right model, also validating available NPSH, operating regime and material compatibility. The service is free of charge for customers in Itaguaí.

Yes — and the secret lies in correct sizing, the main lever for energy efficiency. Both an oversized and an undersized pump waste energy. That is why FB Bombas engineering determines the optimal operating point from the actual process conditions in Itaguaí, balancing the flow/pressure/power ratio.

Yes. FBOT is FB Bombas’ specific centrifugal pump for thermal oil circuits, operating at elevated temperatures with fluids like Therminol, Dowtherm and similar. Material and sealing selection is done according to the maximum operating temperature and type of thermal oil.

Yes. With a factory in Cabreúva/SP and a technical team dedicated to projects in Itaguaí, FB Bombas has manufactured industrial pumps in Brazil since 1944. Applications currently running on imported equipment are covered by the FBCN (centrifugal), FBE/FBEI (gear) and FBOT (thermal oil) series — adding advantages in lead time (no import), factory-direct technical support, spare parts for FB pumps and application engineering that works in Portuguese. In a normalized-line retrofit, the interchangeability set out in ASME B73.1 holds between units of the same standard dimension designation, whatever the original supplier.