FBE Gear Pumps in Alagoa Nova

They are. In energy consumption, nothing weighs more than sizing correctly: oversized or undersized pumps generate waste. FB Bombas engineering's job is to define the ideal operating point for the actual process conditions in Alagoa Nova, optimizing flow, pressure and power together.

It depends on the configuration: standard-arrangement pumps have shorter lead times, while special constructions follow the schedule stated in the technical proposal. The deciding factor is the combination of series, materials and stock availability — and transport to Alagoa Nova goes through our regular road operator.

It does. The standard used is ISO 10816, with velocity RMS in mm/s, and the diagnosis — conducted by FB Bombas application engineering — identifies misalignment, imbalance, bearing defects and cavitation on pumps operating in Alagoa Nova. At startup the baseline is captured; in PM campaigns, spectral comparison is performed; and interventions (re-balancing, bearing replacement, laser alignment) are recommended before vibration enters zone D.

The FB portfolio handles an extensive spectrum of fluids. The FBE series takes mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins plus viscous chemical and hydraulic products; the FBCN series works with raw and treated water, process fluids and industrial effluents; the FBOT series is dedicated to thermal oil at elevated temperatures. Each case is sized considering viscosity, temperature and chemical compatibility.

They are. For each delivery to Alagoa Nova, FB Bombas assembles the unit's complete technical Data Book, containing: hydraulic test certificate, material certificates — stainless steel, duplex or ductile cast iron, per spec —, ISO 21940 G2.5 balancing report, characteristic curve obtained on the bench, API 682 mechanical-seal data sheets, operation and maintenance manual and as-built drawings. Full traceability happens through the serial number.

There is no single configuration — engineering selects the mechanical seal based on the fluid, temperature and operating pressure. The range includes single seals, double seals in tandem or back-to-back arrangement, cartridge seals and packing glands in specific applications. When the fluid is hazardous, the recommendation is a double seal with barrier.

Shipment is by road via BR-101 (via PE), with industrial packaging suited to the journey and tracking until delivery. Sizing, proposal and technical support run in parallel through remote channels — distance does not change the engineering scope, only the logistics planning, reflected in the proposal schedule.

Each series has its thermal limit: with heating jacket and special sealing, FBE and FBEI reach 350°C; FBOT hits the same 350°C in thermal oil circuits; FBCN goes up to 260°C when fitted with proper materials and sealing. Safe operation requires correctly sized sealing and materials.

Yes, when the dimension designation matches. The FBCN series follows ASME B73.1 (North American dimensional standard for end-suction process pumps), which requires pumps of the same designation, from any source of supply, to be interchangeable as to mounting dimensions, suction and discharge nozzles, input shaft, baseplate and foundation bolt holes — in Alagoa Nova plants this applies to the installed normalized fleet. FB Bombas supplies the complete pump, not loose parts: baseplate, piping and foundation stay, and a new FBCN goes in. Before supply, application engineering checks the duty point (Q×H), available NPSH and flange class — a matching designation alone does not guarantee hydraulic equivalence.

Credentials include an active Petrobras CRCC, API 676 compliance on the FBE gear line, ASME B73.1 compliance on the FBCN centrifugal and adherence to NFPA 20 and NBR 16704 on fire-fighting systems. Technical documentation and data book accompany supplies upon requirement.