FBE Gear Pumps in Itapema

Yes. For projects in Itapema, on-site technical visits by application engineers can be scheduled for process data collection, diagnosis of existing installations and commissioning support. Geographic proximity makes this operation agile and recurring.

Yes. Every FB Bombas pump delivered to Itapema comes with a complete technical Data Book: hydraulic test certificate, material certificates (stainless, duplex, ductile cast iron per spec), ISO 21940 G2.5 balancing report, characteristic curve measured on the bench, API 682 mechanical-seal data sheets, operation and maintenance manual, and as-built drawings. All documentation is traceable by the unit serial number.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Itapema, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

Service to Itapema is handled directly by the FB Bombas team at the Cabreúva/SP factory — no intermediaries, no resellers. That means direct contact with application engineering for sizing, technical quotes returned within 24h and original spare parts supplied without distributor markup. On-site technical visits to Itapema are planned based on project criticality.

The FB Bombas rotating set is balanced per ISO 21940 G2.5 (a balancing grade equivalent to API 610 requirements for heavy-duty service) — required for critical projects in Itapema with continuous regime, plants with online vibration monitoring or applications with high cost of unplanned downtime. For machines running above 3,600 RPM or with rotating mass over 50 kg, balancing is performed on two planes with a piezoelectric sensor.

Maximum temperature depends on the series: FBE and FBEI operate up to 350°C with heating jacket and special sealing; FBOT operates up to 350°C in thermal oil circuits; FBCN operates up to 250°C with proper materials and sealing. Correct sizing of sealing and materials is essential for safe operation.

For critical parts (mechanical seal, impeller, shaft, wear ring, bearings) during a plant shutdown in Itapema, FB Bombas runs an emergency flow: pre-invoicing, priority dispatch and alternative modal (express road or air transport depending on distance and criticality). Typical lead time varies by region, with a window negotiable case by case. For customers with an installed base and scheduled PM, part of the stock can be kept on consignment at the plant.

Yes. The FBCN series follows ASME B73.1 normalization (North American dimensional standard for end-suction process pumps) — which makes the pump-and-motor set interchangeable with global manufacturers (KSB, Sulzer, Goulds, Flowserve) already installed in plants in Itapema. For retrofits, the existing baseplate, suction/discharge piping and foundations are usually preserved; what changes is the rotating set. FB application engineering performs the dimensional gap analysis prior to supply.

Yes. FB Bombas offers retrofit of existing installations, including seal upgrades, replacement of worn components, adaptation for new fluids and hydraulic performance improvement. The assessment is based on a technical report of the current installation.

Yes. Correct sizing is the main lever for energy efficiency — an oversized or undersized pump wastes energy. FB Bombas engineering calculates the optimal operating point considering the actual process conditions in Itapema, optimizing the flow/pressure/power ratio.