FBE Gear Pumps in Santo Cristo

Yes. Existing installations can undergo retrofit with FB Bombas — the scope covers seal upgrades, swapping worn components, adaptation for new fluids and hydraulic performance gains. A technical report on the current installation serves as the basis for the assessment.

It does. The standard used is ISO 10816, with velocity RMS in mm/s, and the diagnosis — conducted by FB Bombas application engineering — identifies misalignment, imbalance, bearing defects and cavitation on pumps operating in Santo Cristo. At startup the baseline is captured; in PM campaigns, spectral comparison is performed; and interventions (re-balancing, bearing replacement, laser alignment) are recommended before vibration enters zone D.

It directly affects viscous fluids: viscosity at winter cold start can be several times higher than at operation, raising the torque demanded from the motor. For oils, asphalt and resins, engineering evaluates a heating jacket and sizes the drive for the most severe condition — not the average.

A technical quote for Santo Cristo starts with the application briefing, sent via website form, WhatsApp +55 11 97287-4837 or email comercial@fbbombas.com.br. Required items: fluid name with viscosity at operating temperature, target flow (m³/h), discharge head (m), available NPSH, operating temperature and whether the regime is continuous or intermittent. Once the analysis is complete, application engineering replies bringing a preliminary technical proposal, characteristic curve, suggested materials and delivery lead time.

Yes. The process starts with FB Bombas' application engineering, which studies the installed pump's specifications — flow, pressure, viscosity, temperature — and indicates the dimensional or functional technical equivalence within our series. In Santo Cristo, many clients have already completed this swap and gained in lead time, cost and local support.

For critical parts (mechanical seal, impeller, shaft, wear ring, bearings) during a plant shutdown in Santo Cristo, FB Bombas runs an emergency flow: pre-invoicing, priority dispatch and alternative modal (express road or air transport depending on distance and criticality). Typical lead time varies by region, with a window negotiable case by case. For customers with an installed base and scheduled PM, part of the stock can be kept on consignment at the plant.

Yes, provided the dimension designation coincides. By following ASME B73.1 — the North American dimensional standard for end-suction process pumps — the FBCN occupies the standardised installation envelope defined by the norm, which does not depend on who built the pump running in Santo Cristo plants. What is supplied is the complete pump: baseplate, suction/discharge piping and foundations usually remain. FB application engineering runs the dimensional gap analysis before supply, covering flow, head and required NPSH as well.

Yes. On the factory bench in Cabreúva/SP the FAT (Factory Acceptance Test) is carried out: hydraulic test with characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. The SAT (Site Acceptance Test) on Santo Cristo projects counts on application engineering during commissioning, including startup checklist, laser alignment and recording of the baseline vibration signature.

Application engineering starts from four variables — flow, differential pressure, temperature and viscosity — and refines with available NPSH, duty cycle and chemical compatibility. The study is free for customers in Santo Cristo and results in the exact model recommendation, not a generic family.

Yes. For stationary fire protection systems, FB Bombas produces pumps compliant with NFPA (National Fire Protection Association) and with ABNT's NBR 16704 — covering building and industrial projects that demand these certifications.