FBE Gear Pumps in Cruzeiro do Sul

Yes. The FBCN series complies with ASME B73.1 (North American standard for horizontal end-suction process centrifugal pumps) — which enables retrofit on existing baseplates in Cruzeiro do Sul plants, whoever manufactured the installed unit, provided the dimension designation matches. Shaft dimensions, suction/discharge flanges, casing feet and impeller centerline follow the standard: the complete FBCN pump goes in and piping and baseplate stay put.

It directly affects viscous fluids: viscosity at winter cold start can be several times higher than at operation, raising the torque demanded from the motor. For oils, asphalt and resins, engineering evaluates a heating jacket and sizes the drive for the most severe condition — not the average.

FB Bombas' trajectory as an industrial pump manufacturer began in 1944 and adds up to over 82 years of continuous experience. Engineering, manufacturing and testing operate under one roof at the Cabreúva/SP factory — a guarantee of total quality control on every unit that reaches Cruzeiro do Sul and the rest of Brazil.

Yes — with a structural advantage: since the FBE, FBEI, FBCN and FBOT series are manufactured entirely in Brazil, parts ship from the factory itself in Cabreúva/SP, with short lead times for planned shutdowns and priority handling for emergencies. The direct effect is a lower total cost of ownership.

The FB line covers a wide range: mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins, viscous chemical and hydraulic products (FBE series); raw and treated water, process fluids, industrial effluents (FBCN series); thermal oil at elevated temperatures (FBOT series). Each application is sized according to fluid viscosity, temperature and chemical compatibility.

Limits vary by series. FBE and FBEI: up to 350°C, provided a heating jacket and special sealing are used. FBOT: up to 350°C in thermal oil circuits. FBCN: up to 260°C, with materials and sealing suited to the service. Well-sized sealing and materials are a condition for safe operation in these ranges.

Yes — Cruzeiro do Sul is part of FB Bombas’ direct service area. Supply, engineering support and spare parts ship from the factory in Cabreúva/SP; sizing is done at no cost and, when the project is critical, the team evaluates an on-site technical visit.

Yes. FB Bombas is a Brazilian industrial-pump manufacturer since 1944, with a factory in Cabreúva/SP and a technical team for projects in Cruzeiro do Sul. The FBCN (centrifugal), FBE/FBEI (gear) and FBOT (thermal oil) series cover the same applications served by imported equipment — with advantages in lead time (no import), direct factory technical support, spare parts for FB pumps themselves and Portuguese-speaking application engineering. In a normalized centrifugal retrofit, ASME B73.1 requires that units of the same standard dimension designation, from any source of supply, be interchangeable as to mounting dimensions, suction and discharge nozzles, input shaft and foundation bolt holes.

Yes, provided the dimension designation coincides. By following ASME B73.1 — the North American dimensional standard for end-suction process pumps — the FBCN occupies the standardised installation envelope defined by the norm, which does not depend on who built the pump running in Cruzeiro do Sul plants. What is supplied is the complete pump: baseplate, suction/discharge piping and foundations usually remain. FB application engineering runs the dimensional gap analysis before supply, covering flow, head and required NPSH as well.

For critical parts (mechanical seal, impeller, shaft, wear ring, bearings) during a plant shutdown in Cruzeiro do Sul, FB Bombas runs an emergency flow: pre-invoicing, priority dispatch and alternative modal (express road or air transport depending on distance and criticality). Typical lead time varies by region, with a window negotiable case by case. For customers with an installed base and scheduled PM, part of the stock can be kept on consignment at the plant.