FBE Gear Pumps in Butiá

Yes. The process starts with FB Bombas' application engineering, which studies the installed pump's specifications — flow, pressure, viscosity, temperature — and indicates the dimensional or functional technical equivalence within our series. In Butiá, many clients have already completed this swap and gained in lead time, cost and local support.

Yes — Butiá is part of FB Bombas’ direct service area. Supply, engineering support and spare parts ship from the factory in Cabreúva/SP; sizing is done at no cost and, when the project is critical, the team evaluates an on-site technical visit.

FB pumps are supplied with a warranty against manufacturing defects according to the terms detailed in the commercial proposal. The warranty assumes installation, operation and maintenance within the parameters specified in the manual and sizing performed by engineering. Consult our technical team for specific details of your project in Butiá.

Send the application data through the website form, WhatsApp +55 11 97287-4837 or email comercial@fbbombas.com.br: fluid (name and viscosity at operating temperature), target flow in m³/h, discharge head in m, available NPSH, operating temperature and regime — continuous or intermittent. After reviewing the briefing, application engineering returns a preliminary technical proposal, characteristic curve, suggested materials and delivery lead time for your project in Butiá.

It directly affects viscous fluids: viscosity at winter cold start can be several times higher than at operation, raising the torque demanded from the motor. For oils, asphalt and resins, engineering evaluates a heating jacket and sizes the drive for the most severe condition — not the average.

Yes. Existing installations can undergo retrofit with FB Bombas — the scope covers seal upgrades, swapping worn components, adaptation for new fluids and hydraulic performance gains. A technical report on the current installation serves as the basis for the assessment.

Three fluid fronts are covered by the FB series. FBE: mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins, viscous chemical and hydraulic products. FBCN: raw and treated water, process fluids and industrial effluents. FBOT: thermal oil at elevated temperatures. Fluid viscosity, temperature and chemical compatibility guide the sizing of every application.

It does. The standard used is ISO 10816, with velocity RMS in mm/s, and the diagnosis — conducted by FB Bombas application engineering — identifies misalignment, imbalance, bearing defects and cavitation on pumps operating in Butiá. At startup the baseline is captured; in PM campaigns, spectral comparison is performed; and interventions (re-balancing, bearing replacement, laser alignment) are recommended before vibration enters zone D.

It does. The technical support and logistics covering Butiá are the same applied to the metropolitan region and nearby microregions. That operating radius enables coordinated service to industrial plants distributed across several cities.

FB Bombas holds: active CRCC at Petrobras (supplier registry for Oil & Gas); compliance with API 676 (international standard for positive displacement pumps — FBE series); compliance with ASME B73.1 (standard for process centrifugal pumps — FBCN series); compliance with NFPA (National Fire Protection Association) standards and ABNT NBR 16704 for stationary fire protection pump systems.