FBE Gear Pumps in Alvorada

It directly affects viscous fluids: viscosity at winter cold start can be several times higher than at operation, raising the torque demanded from the motor. For oils, asphalt and resins, engineering evaluates a heating jacket and sizes the drive for the most severe condition — not the average.

FB Bombas has been manufacturing industrial pumps since 1944, with over 82 years of continuous experience. The factory in Cabreúva/SP operates with engineering, manufacturing and testing under one roof, ensuring total quality control on every unit supplied to Alvorada and all of Brazil.

It does. FB Bombas' retrofit service for existing installations encompasses updated seals, replaced worn components, adjustment to new fluids and improved hydraulic performance. To evaluate each case, the reference is the technical report on the current installation.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Alvorada, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

Yes — with a structural advantage: since the FBE, FBEI, FBCN and FBOT series are manufactured entirely in Brazil, parts ship from the factory itself in Cabreúva/SP, with short lead times for planned shutdowns and priority handling for emergencies. The direct effect is a lower total cost of ownership.

Application engineering starts from four variables — flow, differential pressure, temperature and viscosity — and refines with available NPSH, duty cycle and chemical compatibility. The study is free for customers in Alvorada and results in the exact model recommendation, not a generic family.

Yes, we do. Supply for Alvorada ships directly from the factory in Cabreúva/SP and includes engineering support, spare parts for all four series and free sizing — critical projects may receive an on-site technical visit.

Yes. By following ASME B73.1 — the North American dimensional standard for end-suction process pumps —, the FBCN series delivers a pump-and-motor set interchangeable with equipment from global manufacturers (KSB, Sulzer, Goulds, Flowserve) present in Alvorada plants. In a retrofit, the existing baseplate, suction/discharge piping and foundations usually remain; the swap focuses on the rotating set. Prior to supply, FB application engineering conducts the dimensional gap analysis.

Yes. The design of the FBE and FBCN lines favors direct access to wear-prone components — disassembly and inspection are done with conventional tools. The routine gets even simpler with detailed technical manuals and replacement parts supplied straight from the factory.

FB pumps are supplied with a warranty against manufacturing defects according to the terms detailed in the commercial proposal. The warranty assumes installation, operation and maintenance within the parameters specified in the manual and sizing performed by engineering. Consult our technical team for specific details of your project in Alvorada.