FBE Gear Pumps in Picos

It offers both. The FAT (Factory Acceptance Test) takes place on the Cabreúva/SP bench and covers hydraulic testing, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration; when the customer specifies, inspection witnesses the tests. In the SAT (Site Acceptance Test) of Picos projects, application engineering supports commissioning with startup checklist, laser alignment and capture of the baseline vibration signature.

They are. For each delivery to Picos, FB Bombas assembles the unit's complete technical Data Book, containing: hydraulic test certificate, material certificates — stainless steel, duplex or ductile cast iron, per spec —, ISO 21940 G2.5 balancing report, characteristic curve obtained on the bench, API 682 mechanical-seal data sheets, operation and maintenance manual and as-built drawings. Full traceability happens through the serial number.

Yes — with a structural advantage: since the FBE, FBEI, FBCN and FBOT series are manufactured entirely in Brazil, parts ship from the factory itself in Cabreúva/SP, with short lead times for planned shutdowns and priority handling for emergencies. The direct effect is a lower total cost of ownership.

Shipment is by road via BR-316 (via MA), with industrial packaging suited to the journey and tracking until delivery. Sizing, proposal and technical support run in parallel through remote channels — distance does not change the engineering scope, only the logistics planning, reflected in the proposal schedule.

Yes. With a factory in Cabreúva/SP and a technical team dedicated to projects in Picos, FB Bombas has manufactured industrial pumps in Brazil since 1944. Applications currently running on imported equipment are covered by the FBCN (centrifugal), FBE/FBEI (gear) and FBOT (thermal oil) series — adding advantages in lead time (no import), factory-direct technical support, spare parts for FB pumps and application engineering that works in Portuguese. In a normalized-line retrofit, the interchangeability set out in ASME B73.1 holds between units of the same standard dimension designation, whatever the original supplier.

It does. FB pumps for stationary fire protection systems follow the NFPA standard (National Fire Protection Association) and ABNT's NBR 16704, requirements demanded in building and industrial projects that call for these certifications.

The advantages are concrete: faster delivery because nothing depends on imports; FB engineering providing direct technical support; spares secured by in-house parts manufacturing; local-currency pricing, free from exchange rate exposure; and physical presence on projects in Picos and surrounding areas. All from a company manufacturing in Brazil since 1944.

Yes. FB Bombas application engineering supports ISO 10816 vibration analysis (velocity RMS in mm/s) for diagnosing misalignment, imbalance, bearing defects and cavitation on pumps installed in Picos. The service includes baseline capture at startup, spectral comparison during PM campaigns, and intervention recommendations (re-balancing, bearing replacement, laser alignment) before vibration exceeds the standard’s zone D.

Yes. Existing installations can undergo retrofit with FB Bombas — the scope covers seal upgrades, swapping worn components, adaptation for new fluids and hydraulic performance gains. A technical report on the current installation serves as the basis for the assessment.

Each series has its thermal limit: with heating jacket and special sealing, FBE and FBEI reach 350°C; FBOT hits the same 350°C in thermal oil circuits; FBCN goes up to 260°C when fitted with proper materials and sealing. Safe operation requires correctly sized sealing and materials.