FBE Gear Pumps in Capoeiras

Yes. On the factory bench in Cabreúva/SP the FAT (Factory Acceptance Test) is carried out: hydraulic test with characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. The SAT (Site Acceptance Test) on Capoeiras projects counts on application engineering during commissioning, including startup checklist, laser alignment and recording of the baseline vibration signature.

They are. For each delivery to Capoeiras, FB Bombas assembles the unit's complete technical Data Book, containing: hydraulic test certificate, material certificates — stainless steel, duplex or ductile cast iron, per spec —, ISO 21940 G2.5 balancing report, characteristic curve obtained on the bench, API 682 mechanical-seal data sheets, operation and maintenance manual and as-built drawings. Full traceability happens through the serial number.

It does. FB pumps for stationary fire protection systems follow the NFPA standard (National Fire Protection Association) and ABNT's NBR 16704, requirements demanded in building and industrial projects that call for these certifications.

Coverage against manufacturing defects accompanies the supply of FB pumps — the full terms appear in the commercial proposal. It holds as long as installation, operation and maintenance follow what the manual specifies and the sizing performed by engineering. Our technical team clarifies the specific conditions of your project in Capoeiras.

Yes. The design of the FBE and FBCN lines favors direct access to wear-prone components — disassembly and inspection are done with conventional tools. The routine gets even simpler with detailed technical manuals and replacement parts supplied straight from the factory.

Send the application data through the website form, WhatsApp +55 11 97287-4837 or email comercial@fbbombas.com.br: fluid (name and viscosity at operating temperature), target flow in m³/h, discharge head in m, available NPSH, operating temperature and regime — continuous or intermittent. After reviewing the briefing, application engineering returns a preliminary technical proposal, characteristic curve, suggested materials and delivery lead time for your project in Capoeiras.

It is compatible when the dimension designation is the same. ASME B73.1 (North American dimensional standard for end-suction process pumps), adopted in the FBCN series, defines an envelope common to the whole normalized fleet operating in Capoeiras plants, whoever manufactured the installed unit. In a typical retrofit, baseplate, suction/discharge piping and foundations are preserved, and FB Bombas supplies the complete new pump — not loose parts for third-party equipment. The dimensional and hydraulic gap analysis is executed by application engineering before supplying.

They are. In energy consumption, nothing weighs more than sizing correctly: oversized or undersized pumps generate waste. FB Bombas engineering's job is to define the ideal operating point for the actual process conditions in Capoeiras, optimizing flow, pressure and power together.

Since 1944 — over 82 years of continuous experience manufacturing industrial pumps. In Cabreúva/SP, the factory brings engineering, manufacturing and testing together under one roof, which assures total quality control on each unit shipped to Capoeiras and all across Brazil.

It does. The standard used is ISO 10816, with velocity RMS in mm/s, and the diagnosis — conducted by FB Bombas application engineering — identifies misalignment, imbalance, bearing defects and cavitation on pumps operating in Capoeiras. At startup the baseline is captured; in PM campaigns, spectral comparison is performed; and interventions (re-balancing, bearing replacement, laser alignment) are recommended before vibration enters zone D.