FBE Gear Pumps in Palmas

Maximum temperature depends on the series: FBE and FBEI operate up to 350°C with heating jacket and special sealing; FBOT operates up to 350°C in thermal oil circuits; FBCN operates up to 260°C with proper materials and sealing. Correct sizing of sealing and materials is essential for safe operation.

Yes, provided the dimension designation coincides. By following ASME B73.1 — the North American dimensional standard for end-suction process pumps — the FBCN occupies the standardised installation envelope defined by the norm, which does not depend on who built the pump running in Palmas plants. What is supplied is the complete pump: baseplate, suction/discharge piping and foundations usually remain. FB application engineering runs the dimensional gap analysis before supply, covering flow, head and required NPSH as well.

Yes. FB Bombas serves the entire metropolitan region and microregions neighboring Palmas with the same technical support and logistics structure. This regional reach allows serving industrial plants distributed across multiple cities in a coordinated way.

It directly affects viscous fluids: viscosity at winter cold start can be several times higher than at operation, raising the torque demanded from the motor. For oils, asphalt and resins, engineering evaluates a heating jacket and sizes the drive for the most severe condition — not the average.

It depends on the configuration: standard-arrangement pumps have shorter lead times, while special constructions follow the schedule stated in the technical proposal. The deciding factor is the combination of series, materials and stock availability — and transport to Palmas goes through our regular road operator.

They do. The FBCN series dimensionally meets ASME B73.1, the North American standard for horizontal end-suction process centrifugal pumps. In practice, a Palmas plant running a normalized pump of the same designation achieves retrofit on the already-installed baseplate: since shaft dimensions, suction/discharge flanges, casing feet and impeller centerline follow the same standard, the FBCN pump takes the place of the previous one — piping and baseplate stay intact. Hydraulic equivalence (Q×H and NPSH) is checked separately, on the data sheet.

It does. FB Bombas' technical training program for operators and maintainers in Palmas covers: characteristic-curve reading and sizing, cavitation identified via NPSH, mechanical-seal troubleshooting, laser alignment, vibration analyzed per ISO 10816 and preventive maintenance (PM) practice, including bearing and wear-ring replacement. Location and format are flexible — customer plant or the Cabreúva/SP factory, in person or hybrid.

Yes. A complete technical Data Book accompanies each FB Bombas pump that reaches Palmas: hydraulic test certificate, material certificates (stainless steel, duplex and ductile cast iron per spec), ISO 21940 G2.5 balancing report, characteristic curve measured on the test bench, API 682 mechanical-seal data sheets, operation and maintenance manual and as-built drawings. The unit serial number traces all this documentation.

When there is a plant shutdown in Palmas, FB Bombas triggers an emergency flow dedicated to critical parts (mechanical seal, impeller, shaft, wear ring, bearings): the order gets pre-invoicing, dispatch is prioritized and the modal can change — express road or air, decided by distance and criticality. The region defines the typical lead time, with a window negotiable for each case. For those with an installed base and scheduled PM, there is the option of consigning part of the stock at the plant.

Four pillars: a current Petrobras CRCC registration for Oil & Gas; API 676 (positive displacement) on the FBE series; ASME B73.1 (process centrifugals) on the FBCN series; and NFPA 20 / NBR 16704 compliance for stationary fire pumps.