FBE Gear Pumps in Assaí

Yes. With a factory in Cabreúva/SP and a technical team dedicated to projects in Assaí, FB Bombas has manufactured industrial pumps in Brazil since 1944. Applications currently running on imported equipment are covered by the FBCN (centrifugal), FBE/FBEI (gear) and FBOT (thermal oil) series — adding advantages in lead time (no import), factory-direct technical support, spare parts for FB pumps and application engineering that works in Portuguese. In a normalized-line retrofit, the interchangeability set out in ASME B73.1 holds between units of the same standard dimension designation, whatever the original supplier.

Yes. FB Bombas manufactures pumps for stationary fire protection systems in compliance with NFPA (National Fire Protection Association) and ABNT NBR 16704 standards, serving building and industrial projects that require these certifications.

Yes, provided the dimension designation coincides. By following ASME B73.1 — the North American dimensional standard for end-suction process pumps — the FBCN occupies the standardised installation envelope defined by the norm, which does not depend on who built the pump running in Assaí plants. What is supplied is the complete pump: baseplate, suction/discharge piping and foundations usually remain. FB application engineering runs the dimensional gap analysis before supply, covering flow, head and required NPSH as well.

FB Bombas' trajectory as an industrial pump manufacturer began in 1944 and adds up to over 82 years of continuous experience. Engineering, manufacturing and testing operate under one roof at the Cabreúva/SP factory — a guarantee of total quality control on every unit that reaches Assaí and the rest of Brazil.

There is no single configuration — engineering selects the mechanical seal based on the fluid, temperature and operating pressure. The range includes single seals, double seals in tandem or back-to-back arrangement, cartridge seals and packing glands in specific applications. When the fluid is hazardous, the recommendation is a double seal with barrier.

Yes. The process starts with FB Bombas' application engineering, which studies the installed pump's specifications — flow, pressure, viscosity, temperature — and indicates the dimensional or functional technical equivalence within our series. In Assaí, many clients have already completed this swap and gained in lead time, cost and local support.

Application engineering starts from four variables — flow, differential pressure, temperature and viscosity — and refines with available NPSH, duty cycle and chemical compatibility. The study is free for customers in Assaí and results in the exact model recommendation, not a generic family.

It does. The standard used is ISO 10816, with velocity RMS in mm/s, and the diagnosis — conducted by FB Bombas application engineering — identifies misalignment, imbalance, bearing defects and cavitation on pumps operating in Assaí. At startup the baseline is captured; in PM campaigns, spectral comparison is performed; and interventions (re-balancing, bearing replacement, laser alignment) are recommended before vibration enters zone D.

It does. FB Bombas' retrofit service for existing installations encompasses updated seals, replaced worn components, adjustment to new fluids and improved hydraulic performance. To evaluate each case, the reference is the technical report on the current installation.

Yes. The FBCN series complies with ASME B73.1 (North American standard for horizontal end-suction process centrifugal pumps) — which enables retrofit on existing baseplates in Assaí plants, whoever manufactured the installed unit, provided the dimension designation matches. Shaft dimensions, suction/discharge flanges, casing feet and impeller centerline follow the standard: the complete FBCN pump goes in and piping and baseplate stay put.