FBE Gear Pumps in Altônia

Yes. FB Bombas manufactures pumps for stationary fire protection systems in compliance with NFPA (National Fire Protection Association) and ABNT NBR 16704 standards, serving building and industrial projects that require these certifications.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Altônia, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

Yes. FB Bombas application engineering supports ISO 10816 vibration analysis (velocity RMS in mm/s) for diagnosing misalignment, imbalance, bearing defects and cavitation on pumps installed in Altônia. The service includes baseline capture at startup, spectral comparison during PM campaigns, and intervention recommendations (re-balancing, bearing replacement, laser alignment) before vibration exceeds the standard’s zone D.

Yes. FB Bombas offers retrofit of existing installations, including seal upgrades, replacement of worn components, adaptation for new fluids and hydraulic performance improvement. The assessment is based on a technical report of the current installation.

Service to Altônia is handled directly by the FB Bombas team at the Cabreúva/SP factory — no intermediaries, no resellers. That means direct contact with application engineering for sizing, technical quotes returned within 24h and original spare parts supplied without distributor markup. On-site technical visits to Altônia are planned based on project criticality.

FB Bombas holds: active CRCC at Petrobras (supplier registry for Oil & Gas); compliance with API 676 (international standard for positive displacement pumps — FBE series); compliance with API 610 (standard for centrifugal pumps in refineries — FBCN series); compliance with NFPA (National Fire Protection Association) standards and ABNT NBR 16704 for stationary fire protection pump systems.

Yes. FB Bombas’ application engineering analyzes the installed pump specifications (flow, pressure, viscosity, temperature) and proposes dimensional or functional technical equivalence with one of our series. Many clients in Altônia have already made this replacement with gains in lead time, cost and local support.

Yes. Since FB Bombas manufactures entirely in Cabreúva/SP, replacement parts for the FBE, FBEI, FBCN and FBOT series are available directly from the factory, with short lead times for scheduled stops and priority service for emergencies. This significantly reduces total cost of ownership.

Yes. The FBCN series follows ASME B73.1 normalization (North American dimensional standard for end-suction process pumps) — which makes the pump-and-motor set interchangeable with global manufacturers (KSB, Sulzer, Goulds, Flowserve) already installed in plants in Altônia. For retrofits, the existing baseplate, suction/discharge piping and foundations are usually preserved; what changes is the rotating set. FB application engineering performs the dimensional gap analysis prior to supply.

Yes. FB Bombas serves Altônia and the entire surrounding region with supply, technical support and replacement parts directly from the factory in Cabreúva/SP. Support includes sizing at no cost and, for critical projects, on-site technical visits.