FBE Gear Pumps in São Gonçalo do Rio Abaixo

They do. The FBCN series dimensionally meets ASME B73.1, the North American standard for horizontal end-suction process centrifugal pumps. In practice, a São Gonçalo do Rio Abaixo plant running a normalized pump of the same designation achieves retrofit on the already-installed baseplate: since shaft dimensions, suction/discharge flanges, casing feet and impeller centerline follow the same standard, the FBCN pump takes the place of the previous one — piping and baseplate stay intact. Hydraulic equivalence (Q×H and NPSH) is checked separately, on the data sheet.

Coverage against manufacturing defects accompanies the supply of FB pumps — the full terms appear in the commercial proposal. It holds as long as installation, operation and maintenance follow what the manual specifies and the sizing performed by engineering. Our technical team clarifies the specific conditions of your project in São Gonçalo do Rio Abaixo.

ISO 21940 G2.5 is the grade applied to the rotating set of FB Bombas pumps — direct equivalence with what API 610 asks for heavy-duty service. Critical projects in São Gonçalo do Rio Abaixo depend on this standard: continuous-regime operation, online vibration monitoring at the plant or high cost tied to unplanned downtime. When rotation exceeds 3,600 RPM or rotating mass goes over 50 kg, two-plane balancing is executed using a piezoelectric sensor.

It offers both. The FAT (Factory Acceptance Test) takes place on the Cabreúva/SP bench and covers hydraulic testing, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration; when the customer specifies, inspection witnesses the tests. In the SAT (Site Acceptance Test) of São Gonçalo do Rio Abaixo projects, application engineering supports commissioning with startup checklist, laser alignment and capture of the baseline vibration signature.

They are. In energy consumption, nothing weighs more than sizing correctly: oversized or undersized pumps generate waste. FB Bombas engineering's job is to define the ideal operating point for the actual process conditions in São Gonçalo do Rio Abaixo, optimizing flow, pressure and power together.

The FB line covers a wide range: mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins, viscous chemical and hydraulic products (FBE series); raw and treated water, process fluids, industrial effluents (FBCN series); thermal oil at elevated temperatures (FBOT series). Each application is sized according to fluid viscosity, temperature and chemical compatibility.

Yes. On pumps installed in São Gonçalo do Rio Abaixo, FB Bombas application engineering applies ISO 10816 (velocity RMS in mm/s) to diagnose misalignment, imbalance, bearing defects and cavitation. The scope covers baseline captured at startup, spectral comparison throughout PM campaigns and recommendation of interventions — re-balancing, bearing replacement, laser alignment — before the machine reaches the standard's zone D.

Yes. Since FB Bombas manufactures entirely in Cabreúva/SP, replacement parts for the FBE, FBEI, FBCN and FBOT series are available directly from the factory, with short lead times for scheduled stops and priority service for emergencies. This significantly reduces total cost of ownership.

It is. From the data of the pump in operation (flow, pressure, viscosity, temperature), FB Bombas' application engineering proposes a technical equivalence — dimensional or functional — with one of our series. This replacement has already been done by many clients in São Gonçalo do Rio Abaixo, with benefits in lead time, cost and local support.

During a plant shutdown in São Gonçalo do Rio Abaixo, critical parts — mechanical seal, impeller, shaft, wear ring, bearings — enter FB Bombas' emergency flow: pre-invoicing, priority dispatch and choice of alternative modal (express road or air, depending on distance and criticality). Typical lead time depends on the region and the window is negotiated case by case. Customers with an installed base and scheduled PM can keep part of the stock on consignment at the plant.