FBE Gear Pumps in Paraibano

Yes, provided the dimension designation coincides. By following ASME B73.1 — the North American dimensional standard for end-suction process pumps — the FBCN occupies the standardised installation envelope defined by the norm, which does not depend on who built the pump running in Paraibano plants. What is supplied is the complete pump: baseplate, suction/discharge piping and foundations usually remain. FB application engineering runs the dimensional gap analysis before supply, covering flow, head and required NPSH as well.

It does. FB Bombas' technical training program for operators and maintainers in Paraibano covers: characteristic-curve reading and sizing, cavitation identified via NPSH, mechanical-seal troubleshooting, laser alignment, vibration analyzed per ISO 10816 and preventive maintenance (PM) practice, including bearing and wear-ring replacement. Location and format are flexible — customer plant or the Cabreúva/SP factory, in person or hybrid.

It does. FB pumps for stationary fire protection systems follow the NFPA standard (National Fire Protection Association) and ABNT's NBR 16704, requirements demanded in building and industrial projects that call for these certifications.

FB Bombas' rotating set balancing follows ISO 21940 G2.5 — a grade equivalent to the API 610 requirement for heavy-duty service. It is the level demanded in critical Paraibano projects: continuous regime, plants with online vibration monitoring or operations where unplanned downtime is expensive. Above 3,600 RPM or with rotating mass beyond 50 kg, balancing is done on two planes, with a piezoelectric sensor.

Shipment is by road via BR-135 (via Belém-Brasília BR-153), with industrial packaging suited to the journey and tracking until delivery. Sizing, proposal and technical support run in parallel through remote channels — distance does not change the engineering scope, only the logistics planning, reflected in the proposal schedule.

Send the application data through the website form, WhatsApp +55 11 97287-4837 or email comercial@fbbombas.com.br: fluid (name and viscosity at operating temperature), target flow in m³/h, discharge head in m, available NPSH, operating temperature and regime — continuous or intermittent. After reviewing the briefing, application engineering returns a preliminary technical proposal, characteristic curve, suggested materials and delivery lead time for your project in Paraibano.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Paraibano, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

Maximum temperature depends on the series: FBE and FBEI operate up to 350°C with heating jacket and special sealing; FBOT operates up to 350°C in thermal oil circuits; FBCN operates up to 260°C with proper materials and sealing. Correct sizing of sealing and materials is essential for safe operation.

Yes. Since FB Bombas manufactures entirely in Cabreúva/SP, replacement parts for the FBE, FBEI, FBCN and FBOT series are available directly from the factory, with short lead times for scheduled stops and priority service for emergencies. This significantly reduces total cost of ownership.

There are three channels: WhatsApp +55 11 97287-4837, email comercial@fbbombas.com.br and the form on our website. Technical questions get priority response within the same business day — the reply comes directly from application engineering.