FBE Gear Pumps in Iporá

Yes. Correct sizing is the main lever for energy efficiency — an oversized or undersized pump wastes energy. FB Bombas engineering calculates the optimal operating point considering the actual process conditions in Iporá, optimizing the flow/pressure/power ratio.

Yes. FB Bombas application engineering supports ISO 10816 vibration analysis (velocity RMS in mm/s) for diagnosing misalignment, imbalance, bearing defects and cavitation on pumps installed in Iporá. The service includes baseline capture at startup, spectral comparison during PM campaigns, and intervention recommendations (re-balancing, bearing replacement, laser alignment) before vibration exceeds the standard’s zone D.

The FB line covers a wide range: mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins, viscous chemical and hydraulic products (FBE series); raw and treated water, process fluids, industrial effluents (FBCN series); thermal oil at elevated temperatures (FBOT series). Each application is sized according to fluid viscosity, temperature and chemical compatibility.

Yes. Every FB Bombas pump delivered to Iporá comes with a complete technical Data Book: hydraulic test certificate, material certificates (stainless, duplex, ductile cast iron per spec), ISO 21940 G2.5 balancing report, characteristic curve measured on the bench, API 682 mechanical-seal data sheets, operation and maintenance manual, and as-built drawings. All documentation is traceable by the unit serial number.

Yes. FB Bombas offers retrofit of existing installations, including seal upgrades, replacement of worn components, adaptation for new fluids and hydraulic performance improvement. The assessment is based on a technical report of the current installation.

FB Bombas manufactures three major lines: FBE (external gear) for viscous fluids, FBEI (internal gear) for lubricating fluids, FBCN (normalized centrifugal) for water and low-viscosity fluids, and FBOT (specific centrifugal) for thermal oil circuits. We also serve fire protection systems in compliance with NFPA and NBR 16704.

Yes. The FBE and FBCN lines were designed with easy access to wear-prone components, allowing disassembly and inspection with conventional tools. Detailed technical manuals and direct factory replacement parts availability simplify maintenance routines.

Yes. The FBCN series complies with ASME B73.1 (North American standard for horizontal end-suction process centrifugal pumps) — a feature that enables dimensional retrofit on existing baseplates in Iporá plants originally equipped with KSB, Sulzer, Goulds or Flowserve. Shaft dimensions, suction/discharge flanges, casing feet and impeller centerline follow the standard; the rotating set is swapped without changing piping or baseplate.

Maximum temperature depends on the series: FBE and FBEI operate up to 350°C with heating jacket and special sealing; FBOT operates up to 350°C in thermal oil circuits; FBCN operates up to 250°C with proper materials and sealing. Correct sizing of sealing and materials is essential for safe operation.

Shorter delivery times (no import dependency), direct technical support from FB engineering, replacement parts with in-house manufacturing, prices in local currency (no exchange rate exposure) and on-site service for projects in Iporá and surrounding areas. FB Bombas has been manufacturing in Brazil since 1944.