FBE Gear Pumps in Martinópole

Maximum temperature depends on the series: FBE and FBEI operate up to 350°C with heating jacket and special sealing; FBOT operates up to 350°C in thermal oil circuits; FBCN operates up to 250°C with proper materials and sealing. Correct sizing of sealing and materials is essential for safe operation.

Yes. FB Bombas manufactures pumps for stationary fire protection systems in compliance with NFPA (National Fire Protection Association) and ABNT NBR 16704 standards, serving building and industrial projects that require these certifications.

Yes. FB Bombas serves Martinópole and the entire surrounding region with supply, technical support and replacement parts directly from the factory in Cabreúva/SP. Support includes sizing at no cost and, for critical projects, on-site technical visits.

FB Bombas holds: active CRCC at Petrobras (supplier registry for Oil & Gas); compliance with API 676 (international standard for positive displacement pumps — FBE series); compliance with API 610 (standard for centrifugal pumps in refineries — FBCN series); compliance with NFPA (National Fire Protection Association) standards and ABNT NBR 16704 for stationary fire protection pump systems.

Yes. The FBCN series follows ASME B73.1 normalization (North American dimensional standard for end-suction process pumps) — which makes the pump-and-motor set interchangeable with global manufacturers (KSB, Sulzer, Goulds, Flowserve) already installed in plants in Martinópole. For retrofits, the existing baseplate, suction/discharge piping and foundations are usually preserved; what changes is the rotating set. FB application engineering performs the dimensional gap analysis prior to supply.

Yes. Since FB Bombas manufactures entirely in Cabreúva/SP, replacement parts for the FBE, FBEI, FBCN and FBOT series are available directly from the factory, with short lead times for scheduled stops and priority service for emergencies. This significantly reduces total cost of ownership.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Martinópole, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

Yes. Every FB Bombas pump delivered to Martinópole comes with a complete technical Data Book: hydraulic test certificate, material certificates (stainless, duplex, ductile cast iron per spec), ISO 21940 G2.5 balancing report, characteristic curve measured on the bench, API 682 mechanical-seal data sheets, operation and maintenance manual, and as-built drawings. All documentation is traceable by the unit serial number.

Yes. FB Bombas application engineering supports ISO 10816 vibration analysis (velocity RMS in mm/s) for diagnosing misalignment, imbalance, bearing defects and cavitation on pumps installed in Martinópole. The service includes baseline capture at startup, spectral comparison during PM campaigns, and intervention recommendations (re-balancing, bearing replacement, laser alignment) before vibration exceeds the standard’s zone D.

Quotes can be requested via WhatsApp at +55 11 97287-4837, email comercial@fbbombas.com.br or through our website form. Provide the application (fluid, flow, pressure, temperature) and the technical team will respond with a proposal sized for your conditions in Martinópole.