FBE Gear Pumps in Serrinha

Yes. The FBCN series complies with ASME B73.1 (North American standard for horizontal end-suction process centrifugal pumps) — which enables retrofit on existing baseplates in Serrinha plants, whoever manufactured the installed unit, provided the dimension designation matches. Shaft dimensions, suction/discharge flanges, casing feet and impeller centerline follow the standard: the complete FBCN pump goes in and piping and baseplate stay put.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Serrinha, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

Yes. Since FB Bombas manufactures entirely in Cabreúva/SP, replacement parts for the FBE, FBEI, FBCN and FBOT series are available directly from the factory, with short lead times for scheduled stops and priority service for emergencies. This significantly reduces total cost of ownership.

Yes. FB Bombas serves Serrinha and the entire surrounding region with supply, technical support and replacement parts directly from the factory in Cabreúva/SP. Support includes sizing at no cost and, for critical projects, on-site technical visits.

Shipment is by road via BR-116 (via Fernão Dias BR-381 até MG), with industrial packaging suited to the journey and tracking until delivery. Sizing, proposal and technical support run in parallel through remote channels — distance does not change the engineering scope, only the logistics planning, reflected in the proposal schedule.

For critical parts (mechanical seal, impeller, shaft, wear ring, bearings) during a plant shutdown in Serrinha, FB Bombas runs an emergency flow: pre-invoicing, priority dispatch and alternative modal (express road or air transport depending on distance and criticality). Typical lead time varies by region, with a window negotiable case by case. For customers with an installed base and scheduled PM, part of the stock can be kept on consignment at the plant.

Four families are manufactured in Cabreúva/SP: external gear FBE and internal gear FBEI for viscous fluids, standardized centrifugal FBCN for low-viscosity liquids and FBOT for thermal oil circuits up to 350 °C. Fire-fighting systems per NFPA 20 / NBR 16704 complete the line.

Yes. On pumps installed in Serrinha, FB Bombas application engineering applies ISO 10816 (velocity RMS in mm/s) to diagnose misalignment, imbalance, bearing defects and cavitation. The scope covers baseline captured at startup, spectral comparison throughout PM campaigns and recommendation of interventions — re-balancing, bearing replacement, laser alignment — before the machine reaches the standard's zone D.

Three paths lead to a quote: the website form, WhatsApp +55 11 97287-4837 and the email comercial@fbbombas.com.br. With the application data in hand (fluid, flow, pressure, temperature), the technical team returns a proposal already sized for your scenario in Serrinha.

FB pumps are supplied with a warranty against manufacturing defects according to the terms detailed in the commercial proposal. The warranty assumes installation, operation and maintenance within the parameters specified in the manual and sizing performed by engineering. Consult our technical team for specific details of your project in Serrinha.