FBE Gear Pumps in Novo Triunfo

Yes. In addition to the standard portfolio, FB Bombas develops custom solutions for special applications, including modifications in construction materials, sealing arrangements, integrated heating systems, skids, mobile assemblies and retrofit of existing installations. Special projects go through engineering before manufacturing.

It does. FB pumps for stationary fire protection systems follow the NFPA standard (National Fire Protection Association) and ABNT's NBR 16704, requirements demanded in building and industrial projects that call for these certifications.

Shorter delivery times (no import dependency), direct technical support from FB engineering, replacement parts with in-house manufacturing, prices in local currency (no exchange rate exposure) and on-site service for projects in Novo Triunfo and surrounding areas. FB Bombas has been manufacturing in Brazil since 1944.

Yes — with a structural advantage: since the FBE, FBEI, FBCN and FBOT series are manufactured entirely in Brazil, parts ship from the factory itself in Cabreúva/SP, with short lead times for planned shutdowns and priority handling for emergencies. The direct effect is a lower total cost of ownership.

Yes. A complete technical Data Book accompanies each FB Bombas pump that reaches Novo Triunfo: hydraulic test certificate, material certificates (stainless steel, duplex and ductile cast iron per spec), ISO 21940 G2.5 balancing report, characteristic curve measured on the test bench, API 682 mechanical-seal data sheets, operation and maintenance manual and as-built drawings. The unit serial number traces all this documentation.

Yes. FB Bombas is a Brazilian industrial-pump manufacturer since 1944, with a factory in Cabreúva/SP and a technical team for projects in Novo Triunfo. The FBCN (centrifugal), FBE/FBEI (gear) and FBOT (thermal oil) series cover the same applications served by imported equipment — with advantages in lead time (no import), direct factory technical support, spare parts for FB pumps themselves and Portuguese-speaking application engineering. In a normalized centrifugal retrofit, ASME B73.1 requires that units of the same standard dimension designation, from any source of supply, be interchangeable as to mounting dimensions, suction and discharge nozzles, input shaft and foundation bolt holes.

Yes. The FAT (Factory Acceptance Test) is executed on the factory bench in Cabreúva/SP, with hydraulic test, characteristic-curve measurement (Q × H), hydraulic efficiency, NPSHr and ISO 10816 vibration — witnessed by customer inspection when specified. For projects in Novo Triunfo, the SAT (Site Acceptance Test) is supported by application engineering during commissioning, with startup checklist, laser alignment and baseline vibration-signature capture.

It does. The standard used is ISO 10816, with velocity RMS in mm/s, and the diagnosis — conducted by FB Bombas application engineering — identifies misalignment, imbalance, bearing defects and cavitation on pumps operating in Novo Triunfo. At startup the baseline is captured; in PM campaigns, spectral comparison is performed; and interventions (re-balancing, bearing replacement, laser alignment) are recommended before vibration enters zone D.

Yes. Correct sizing is the main lever for energy efficiency — an oversized or undersized pump wastes energy. FB Bombas engineering calculates the optimal operating point considering the actual process conditions in Novo Triunfo, optimizing the flow/pressure/power ratio.

Three fluid fronts are covered by the FB series. FBE: mineral and synthetic oils, asphalt (CAP), BPF fuel oils, petroleum derivatives, molasses, resins, viscous chemical and hydraulic products. FBCN: raw and treated water, process fluids and industrial effluents. FBOT: thermal oil at elevated temperatures. Fluid viscosity, temperature and chemical compatibility guide the sizing of every application.